2010-2011 Camaro Control Arm Stiffeners Rear 2 Pc. Pfadt Racing

Stiffening you suspension components is an important factor in getting the most out of your Camaro. Our strong lightweight brace is an inexpensive way to stiffen your weak factory rear toe link. We have designed this brace to slip in place on your existing toe link and box it in for maximum stiffness.

Simply push out your factory bushings, weld the brace to your toe link and re-install your bushings. In the coming weeks we will have a polyurethane bushing set to replace those factory rubber bushings also.

At Pfadt, we are not just content with building products that look pretty. We design all of our pieces to take care of problems and needs that your Camaro has. We started by looking at the factory pieces to see where the deficiencies are. Under a realistic cornering load the deflection in the steel arm itself is 2.4mm. That is obviously not conducive to good handling and cornering feel. The deflection amount is almost exactly the same in compression.

Armed with this information, we decided that we could stiffen up that arm with a simple, inexpensive DIY brace. With the brace installed on the part, the deflection is reduced to less than 1mm with the same load.

* 2 Pc. set for factory rear control arms * Weld on stiffeners